Jump to content

Leaderboard


Popular Content

Showing content with the highest reputation on 08/07/2013 in Posts

  1. 1 point
    Chitzu

    powered paddle boat

    I needed a small boat to putter around in and get through lilly pads so this worked out great. Made from a washer tub,several bicycles and lawnmowers. There is a rudder in back and the wheel adjust up and down to keep the right amount in the water regardless of the load,this is a must have if you build something similar. 5 speed tranny and reverse so I can keep the motor at near idle and is quieter that way. A piece of downspout painted to look like a steamboat stack sets it off.The 14 foot flatbottom boat is just right to get through lilly pads and get up into the trees. You will need a motor with a cast iron flywheel if you use a pushmower engine, I have been able to change over from aluminum to iron on some of the older Briggs.
  2. 1 point
    Chitzu

    mower for allergy sufferers

    Due to allergies I built a cab that is fairly air tight and makeup air is filtered,it works quite well and I don't have to wear that mask. The frame is thin wall 1inch square tubing and plexiglass and plywood make up the rest. Insulated with fiber board,carpet and spray foam. I have 3 good sized 12 volt thermo units on top with a fan cooling those and fans on the inside and a makeup air fan that pulls outside air through the air cleaner. An auto alternator provides power for the units. The large heatsinks are diodes to keep the 12 volt as a clean signal but the thermal units gradually stop working and after 2 years they get cool enough to collect moisture but that is about all, they are not worth the cost which is a fair amount. I am gathering parts to put in freon unit but not till winter, with all this rain I have to mow every 4 days.
  3. 1 point
    Chitzu

    mower for allergy sufferers

    No it is hardly noticeable,I turn it on with a toggle switch and the motor pulls a little bit. With the fans and thermal running it is about 30 amps. The freon pulls a little harder but without those worthless thermal the amp load will be less so it should equal out pretty close. The fun part will be to pull the compressor from the bottom of the motor as I will still need enough amps to run fans on the evaporator and on the condenser and clutch.
  4. 1 point
    Chitzu

    home built 5 foot pull mower

    Don't stop but slowed down after 70. The 2 decks were 30 inch so that makes 60 and depending on the hitch offset the tractor has 36 inch but 7 feet is about all you can do without skipping a patch and old farmers hate point rows HA HA.
×
×
  • Create New...