joegrgraham 30 #1 Posted September 21, 2017 Can someone please advise on the best way to get into the clutch on an mg2? I need to inspect and probably reline it. Also, what size thread is used on the track roller spindles? Is it BSF? Share this post Link to post Share on other sites
Ransomes256 18 #2 Posted September 21, 2017 Joe, The thread on the drive wheel spindles is 5/16" BSF The thread on the load roller spindles is 3/8" BSF You will need the special tool to remove and then split the flywheel and clutch. I loan the tool FOC but require a deposit to ensure return of the tool which I will refund less the cost of post. Neil Share this post Link to post Share on other sites
expeatfarmer 591 #3 Posted September 21, 2017 Neil's tool is the only way to go !!! Share this post Link to post Share on other sites
joegrgraham 30 #4 Posted September 21, 2017 Thanks chaps. Neil, I will be in touch in the next few days to arrange the tool (and a shopping list!). Joe. Share this post Link to post Share on other sites
