Jump to content
Lee

O & R SLA-20 ENGINE RINGS

Recommended Posts

I am new to this site so I hope I am doing this post in the wright place.


I have a Lancaster chain saw with a O & R SLA-20 ENGINE.

I would like to no the size ring it takes.

As near as I can measure it would be about a 1.5mm x 38mm.

I only have a piece of the old ring so it is hard to tell the diameter.

Edited by Lee

Share this post


Link to post
Share on other sites

May have been better to post this in the Forum's Engines Section (O&R) section. The guys in the U.S, will be best placed to offer advice.

Edit=== I now see it was :rolleyes:

Edited by Anglo Traction

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...