DevonianRedneck 86 #1 Posted July 6, 2016 currently looking for, one clutch idler pulley, full brake assm, and tie rods, all for the 604, but i imagine that the earlier commando 8s have a lot of crossover parts, not 100% sure of that though will post pictures of said worn out parts this evening, and for a real long shot, has anyone got the body panel that the rear wings bolt to and a correct pan seat? cheers henry Share this post Link to post Share on other sites
DevonianRedneck 86 #2 Posted July 6, 2016 ps, also could do with but less vital as a suppose i could make one....the brake/clutch linkage rod Share this post Link to post Share on other sites
meadowfield 1,900 #3 Posted July 6, 2016 good luck with that list... Steering rods from any raider/C series will fit. They are as easy to make with new rods ends and some bar... Don't think you will get the rear panel, but it shouldn't be hard to fabricate... Share this post Link to post Share on other sites
DevonianRedneck 86 #4 Posted July 6, 2016 c series ones are considerably longer, ive got a scrap one in the field so i checked, was a bit disheartened to find they where about an inch longer Share this post Link to post Share on other sites
Stormin 4,458 #5 Posted July 6, 2016 See my C-120 refurb topic, Henry. You'll see how to modify yours to suit. Share this post Link to post Share on other sites
DevonianRedneck 86 #7 Posted July 6, 2016 cheers norm i'll take a look Share this post Link to post Share on other sites
neil 524 #8 Posted July 7, 2016 The tie rods are different on the earlier models as the front axle is different to the later models. I have had many parts shipped over from US , although the parts can be quite cheap the shipping cost are a bit painful , but worth it in the end . 1 DevonianRedneck reacted to this Share this post Link to post Share on other sites
