Jump to content

Leaderboard


Popular Content

Showing content with the highest reputation on 06/08/2021 in Posts

  1. 1 point
    Finally got around to getting the "Roper 38" tiller working, modified the hitch pickup mountings to match the 3 point on my C121. My 3 point was originally going to be hydraulic, but getting the geometry right without the whole lot hanging too far back was awkward, due to the under seat fuel tank. So I used a winch instead. This is rated at 2000 lbs with a " snatch block " pulley mounted on the lift arm cross brace, the tiller weighs around 250lbs. I've taken a few photos, but only after everything was fitted.
  2. 0 points
    expeatfarmer

    137 Goes to a new home

    My old MG2 from feb 1936 is about to go to a new home in Gloucestershire. Rebuilt from a pile of scrap in 2016 to as near ex factory as I could get it, it is now time for it to go to a new home, not without a fight though it has not been run for three years so a good day was spent stripping the car. magneto, de- compressor . Surprised myself that I managed to crank start it without immediate cardiac issues!. Last time it was shown I covered it in a mix of WD40 and oil which over the years has collected dust so that it now has a patina that looks it's 86 years. I managed to get it to run and had a good charge around the garden for old time sake. Sad to see it go but too many projects left to deal with. As far as I know 137 is the oldest known MG2 crawler being number 36 of the line, it has the Sturmey Archer 600cc side valve engine fitted with the chain crank starter mechanism, open exhaust and flat top engine cowling fitted with a cycle brake lever to operate the decompressor.
×
×
  • Create New...