duradad 0 #1 Posted Monday at 01:07 AM my Tiger generator is labeled 6v and 12v. D.C. How do you switch between ? Share this post Link to post Share on other sites
Wallfish 715 #2 Posted Tuesday at 12:47 AM ? I don't remember ever seeing 6v. Can you post a pic of it? Tiny Tiger Generator Operating Instructions Models 5001-1 & 5001-2.pdf Share this post Link to post Share on other sites
Wallfish 715 #4 Posted Tuesday at 01:08 AM I think you would need to remove or disconnect one of the diodes. But I'm not sure. Check in the manual I just posted the link of above Did you receive those diaphragms yet? Share this post Link to post Share on other sites
duradad 0 #5 Posted Tuesday at 01:59 AM 49 minutes ago, Wallfish said: I think you would need to remove or disconnect one of the diodes. But I'm not sure. Check in the manual I just posted the link of above Did you receive those diaphra 49 minutes ago, Wallfish said: I think you Did you receive those diaphragms yet? Yes. I sent you a message on this. Did you get my thank you in the mail ? Share this post Link to post Share on other sites
Wallfish 715 #6 Posted Tuesday at 03:34 PM Maybe it's ground a negative wire to the case and the positive post ??? 2 posts are 12v. Do you have a multi meter if it's not in the manual how to achieve the 6v? I breezed through it but didn't see anything. Wish @factory David was still active. He always seemed to have the answers for stuff like this. Share this post Link to post Share on other sites
