Jump to content

Leaderboard


Popular Content

Showing content with the highest reputation on 03/29/2023 in Posts

  1. 1 point
    Stormin

    Free Wheel Horses.

    I received this message today. from Steve Wilson Changing the subject a little, I have 2 C125 wheel horses that I was using in my vineyard until last summer. Someone turned hard right at top speed on one of them and the back axle moved apart a little then jammed. The other was used regularly and I do not think there is much wrong but I cannot get it to start. Unfortunately the vineyard is expanding quickly, it is extremely busy and time consuming. I have owned both both tractors for some years and am very fond of them however I know that I will not have time to look at them this year. If anyone is interested they are available free from the vineyard in Chipping Campden, Gloucestershire, at the very least I am sure that 1 good tractor could be assembled. I can be reached on 07812 339556, 01386 840079 or email steve@steve-w.co.uk If there is a better address for this message to be viewed, I would be pleased to know it. Regards Steve
  2. 1 point
    Anglo Traction

    Bits for my next Project

    Hi Nigel, Good to hear from you and hope all's well. Quite enjoy doing the beating of copper. Just about ready to stitch the cowl/plates together with rivets now that I've nearly sorted the Plug access hole- Meanwhile, I had to come up with a fixing point I'd mentioned to secure the lower part of the cowl. Decided on a split housing so that it can be easily assembled/removed. Machined 2 blocks of Duralumin to identical size, then drilled/tapped to bolt them together. Excellent machining qualities of this metal made it a rather enjoyable job- I was then able to machine the inner diameters to fit the flange it clamps to and clears the crank bearing and shaft by a few thousands of an inch (0.05mm). It will also have a greased felt wiper washer inside to prevent dirt/water ingress- This now gives me a platform to fix the cowl and hold it securely- Have lots of swarf to clean off the machines now!. Regards
  3. 1 point
    Stormin

    Ready for duty.

    Finished putting the C-125 back together after the exhaust valve replacement. Fired it up and let it warm up then set the carb. Got it running nicely, then I notice oil running down the front of the engine. Valve tappet cover leaking. So off with the carb then the cover. Made a new gasket and refitted everything. Fired it up and let it run for a while and no more leak. Refitted the bonnet/hood. Now ready for grass cutting duty again.
×
×
  • Create New...