Leaderboard

Yes. Anything to hold the rope as long as it gets locked on the spool

The wire needs to be bent in such a way to feed both ends of the wire through the holes from inside of the spool out. The factory pieces resemble 1/2 a paper clip and the wire is kind of soft

With a little bit of fuel in the tank, connect a piece of fuel line to the nipple and blow into it. The one that bubbles the fuel is carb line.

The shape of tank. The line from one side to the other allows air to escape out the top. Otherwise the opposite side from the fill neck would just remain an air bubble on the top without it. So that line allows it to fill all the space so the tank holds more fuel

You can get the 2 sections off without removing that hole plug cover

Courtesy of 10242130 Here is a Brochure picture of a Little Petro minibike.It was made in the early to mid 60's by Odom Manufacturing.This is the same company that made the Petro Powered Products Drill that is on this site along with quite a few other Ohllson & Rice powered tools.Jim Odom also Produced the Comet C Saw for Comet.I will be putting pictures of my Little Petro bikes on this site soon,I need to crop them all as the file size's are too big . Only about 12 of these bikes have been located to date,quite a rare bike. This particular Brochure shows the bike with a TAS engine,but early on,they used the Olhsson & Rice. With O&R

I guess now I need to try to find one of these with an O&R for my wifes collection.