HeadExam 1,783 #1 Posted February 19, 2018 I got this saw from Missoula Montana last year for 150 dollars, it didn't have any spark. It is a 7.0 cubic inch 114 cc saw with a 27" roller nose bar. A few weeks back I decided to restore it. The piston and bore were like new, but I replaced the points, condenser, and coil and bought complete new gasket set, the carb had been gone through before I got it so that was good, but the tank had a deep dent in the cover and I bought a new cover, put in new tygon lines and new fuel filter then painted and applied new decals. It has two coats of synthetic alkyd enamel with a poly converter hardener and a synthetic reducer, The saw was clear coated with a two part gloss epoxy. Decals were courtesy of Sugar Creek Supply, the only place to buy decals. I have to paint the muffler shield and install it, the old one was broken and miraculously I found another one intact just last week. 3 Triumph66, Stormin and Wallfish reacted to this Share this post Link to post Share on other sites
Stormin 4,458 #2 Posted February 19, 2018 Nice job, Alain. Share this post Link to post Share on other sites
Triumph66 1,256 #3 Posted February 19, 2018 That's a very tidy job yet again Alain. Share this post Link to post Share on other sites
