Jump to content

Leaderboard


Popular Content

Showing content with the highest reputation on 03/08/2023 in Posts

  1. 1 point
    Anglo Traction

    Bits for my next Project

    Bashing copper seems to be going ok so far. Part way through doming the top to fit the cylinder head. This is to utilise the 1/4"bsf threaded hole in the top to secure it- There will also be a fixing that uses the flange of the crankcase at the shaft bearing output side - Fuel tank caps will be more difficult to form
  2. 1 point
    DustyB

    flywheel key - easy to make

    I just rubbed it on the stone with my finger tip.
  3. 1 point
    Anglo Traction

    Bits for my next Project

    Yes Norm, very handy and will have a fair bit of work for them on this. Not made great progress, but have machine cut/threads on several short rods and finshed the 8 brass nuts from the 1inch A/F (25.4mm) Hex stubs which are shown in the very first image on this. Threaded 1/2" BSF and single chamfer . These represent pre-war A/F (across flats) dimension of the 9/16' Whitworth fixings- Starting on the copper beating now the cushion is filled with sand. Regards
×
×
  • Create New...