Mike in NC

Let try this again

Well she showed up today she looks in good shape I will need to do fuel lines carburetor the normal
don't think I will take it all apart like John but i will use a few Q-tip and clean it up





 

 

 
 
We need a fetcher to turn pic right side up

Thought I would test out an idea on this gas tank repair on the cheap since I’ve got it opened up. When I heated the bottom to loosen the epoxy seal the heat deformed the plastic cone that holds the fuel filter screen on the end of the pickup tube.  I basically modified a 1/8 x 1/8 compression fitting. I drilled out the center so it could slide on the pickup tube all the way through to make it adjustable and easier to set it at the right position just above the bottom of the tank base plate. I then punched out a 1/4” piece of fuel screen and secured it all in place.

Got the urge to play with the drill press out in the 120F garage. Decided to build another stand.  I think this one will be good for engine test runs.
 

Clint I could use 4 or 5 of those just to put some engines on that are just sitting on a shelf

I'm sure I've posted this somewhere on the forum before, here is the parts list for the Orline Utility Pump with O&R Type 217 engine;

 
David

Welcome Mike, there are several different O&R pumps that all seem to use the pump & impeller, I have three different ones here & only one where the impeller is intact, I should really get some measurements from it.
 
This is the impeller remains from my Petro Chug-A-Pump with some measurements (pictures taken years ago).





 
David

We have a pump just like the one pictured. It is missing the pump impeller. Does anyone know where one could be found?  Thanks in advance!!
 
 

Welcome to the forum Mike!  Nice looking pump! I’m missing one of the little pumps as well for a different pump I have. I haven’t been able to locate anything like it yet.  I’ve been tempted to try to find a used transfer pump kind of like this just to see if maybe it would fit.  There are several off-brands of these small pumps so I’m sure one can be found on the cheap.  https://www.northerntool.com/shop/tools/product_200352045_200352045
 

We have a pump just like the one pictured. It is missing the pump impeller. Does anyone know where one could be found?  Thanks in advance!!
 
 

This old school type Chicken Power has been in wind chime mode for a very long time. It was painted probably 5 or 6 years ago and just hanging around on wires. The engine is a very low hour and the recoil was already done, just needed a decal. It took longer to wipe off all of the dust LoL. Still needs some recoil screws but that's about it.
Poor Terry always gets it from me about how long it takes so here ya go Terry, just teed it up for ya. Here's another too, been sanding the parts for that Bee Jay winch and that's the engine in the engine rebuild pics thread from 2015