That looks like a standard Gutbrod rear linkage. As mine is home made do you think it would benefit from me shortening the plough beam as it is very long?
What do you think about the disc culture. It has had a second position drilled further forward as pictured. I think original is the rear mounting position?
Well I finally got the chance for a small go with the new plough I picked up earlier this year.
Need to have more room to set it up with the rear linkage . I think the furrow width is a bit too wide,
video-1507319648.mp4
Latest little build. I needed more hight and reach for cutting a high hedge and this is what I came up with. The old sweeper was past it as the bearings had seized and spun in the chassis. I can stand on the plarform at the very back and not have the steering wheels lift. The front tyres have also been replaced to make them more puncture proof.
Time for a play!
I have just coupled the lawn slitter,aerator behind the spring tines and with a little amount of weight works well. It,s a bit early but I was keen to give it a tryout.
I have found that the Disc mount position is not standard. Once I unbolted it the holes have been gas cut out but you can see the standard position forward of it.
Morning All.
Just picked up the plough yesterday an I was wondering if anyone could recognise it as a known made.
Some one has welded up the disc swivel but not to much wear on the disc bearing . the moldboard adjuster has freed off ok and it just need a clean and paint.
