How about this for a nut splitter.

[sten 84]

Bought this a few years back from a car boot sale, probably never use it but it was cheap. 9 inches long with a capacity of 1.5 to 2 inch nuts.

[pmackellow 2,738]

You could split some big nuts with that sten

[sten 84]

My nuts are too small for this.

[Ian 2,417]

Even if you never use it Sten, it would look great hanging on a workshop wall

 

Now, I could continue with an obvious joke.. But I'm nut going to

[Stormin 4,458]

 

 

 

Now, I could continue with an obvious joke.. But I'm nut going to

 

I bet it's a cracker though.

[neil 524]

Wow, 9 inches long, that's a big tool for 2 inch nuts

[sten 84]

You need a big tool if you've got big nuts

[ih674 14]

I bought a two little teng nut splitters ages ago and used the little one the other day for the first time. It was a nut and Allen head bolt holding pick up reel tines on and the Allen head was chewed up, such a handy tool. Did the nut from each side, tapped it with a hammer and the nut fell off. Saved quite a bit of time on the job as there were about 6 bolts like this with not enough room on the bolt end to get any other tool in.

James

[meadowfield 1,900]

They are useful bits of kit, though always seems to be a nut in a corner where you can't get the splitter in...

[nigel 1,877]

i think your all NUTS!