Anglo Traction 1,016 #1 Posted October 26, 2018 Part of my Workshop stock tidy up. This carb is from a 1981 K301 engine. I have completed what is known as a full rebuild on this and is returned to virtually new condition. What has been done was covered in a Topic on Redsquare a while back, so I've added a link here for scrutiny- -CARB- Yes, you have the option to pay much less for a new Chinese copy, but this one now has quality built into it to run for many more years with some care. It was assembled with a new repair kit, super clean inside and out. Stored in that condition until I set it up on one of my Tractors to adjust the settings for correct running mentioned here in this link- Set up Carb on K301 Returned to storage until now. Should bolt straight onto a K301/M12. Note- this was set up and adjusted on an engine in good condition and a clean Air Filter. You may still need to make further adjustments. Includes the Governor Arm linkage and Fuel inlet elbow £45. 3 HeadExam, Alan and Cub Cadet reacted to this Share this post Link to post Share on other sites
Stormin 4,458 #2 Posted October 26, 2018 I'll have that as well. Well, if swmbo can have a new kitchen, I can have a few tractor bits. Share this post Link to post Share on other sites
Anglo Traction 1,016 #3 Posted October 26, 2018 Consider it yours Norm. SOLD Share this post Link to post Share on other sites
Cub Cadet 613 #4 Posted October 30, 2018 Seems like Norm got all the good stuff! I should check on here more often Share this post Link to post Share on other sites
Stormin 4,458 #5 Posted October 30, 2018 I was at the right place at the right time, Ewan. For a change. I signed on as Richard was posting. 1 Cub Cadet reacted to this Share this post Link to post Share on other sites
