Jump to content

Recommended Posts

Initially , I couldn’t get a spark out of the Kohler K91 fitted to my Allen Scythe .

ordered a new coil from China , couldn’t find one in UK . It turned up today and didn’t fit , the square hole through the middle is only 10 mm across flats and should be 12.5 . Being fairly annoyed , I had another go at getting a spark and after stoning the points and cleaning them again I noticed a weak spark when I spun the engine over fast with my rattle gun ,  put it all back together and it started, loads of blue smoke but pulled in the drive lever and it lurched off .

i bought it ti cut the rushes that are invading our land because the strimmer was killing my back . Not so sure the Allan scythe won’t be worse , it’s a beast 👍 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...