Jump to content

Recommended Posts



Have cleaned the carburettor and am attempting to tune the carburettor to obtain a tick over speed. My mower has the plastic jet which appears to be a simple push on fit.

However when tightening the adjuster screw it reaches the point where the jet falls out Should there be a retainer other than the plastic and steel washers.

When the adjustment screw is open the jet is a tight fit. Would appreciate your views


Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Create New...