Stormin 4,458 #1 Posted June 11, 2014 Can anyone tell me the size of the transmission drive shaft seals for my C-120? Share this post Link to post Share on other sites
meadowfield 1,900 #2 Posted June 11, 2014 The axle ones? Are they 1 1/8" going be buying a few pairs in a few weeks for bendy. Will let you know what they are or how much if you can hang on? Share this post Link to post Share on other sites
Stormin 4,458 #3 Posted June 11, 2014 Cheers Mark. I'll check the shaft dia. No great rush. I'm wanting two sets actually. 120 and 125. Share this post Link to post Share on other sites
the showman 4,074 #4 Posted June 11, 2014 there be 1" 1/8 shafts Norm, I only had the early 1" seals in stock Share this post Link to post Share on other sites
Stormin 4,458 #5 Posted June 11, 2014 Cheers, Chris. Any Idea of O.D. - I.D. and thickness? Share this post Link to post Share on other sites
the showman 4,074 #6 Posted June 11, 2014 what I did, when I wanted the early ones, I ordered them from a toro dealer then when I got them I matched them up from a bearing shop Share this post Link to post Share on other sites
ranger 373 #7 Posted June 11, 2014 just bought a couple through Amazon 1-1/8" x 1-3/8" x 1/8" SKF 11050 for the 8 speed, not sure if the hydro`s have a differant o/d. Share this post Link to post Share on other sites
Stormin 4,458 #8 Posted June 12, 2014 Thanks Ranger. I can pick some up tomorrow. Share this post Link to post Share on other sites
Ian 2,417 #9 Posted June 12, 2014 just bought a couple through Amazon 1-1/8" x 1-3/8" x 1/8" SKF 11050 for the 8 speed, not sure if the hydro`s have a differant o/d. The hydro seals are the same size (Eaton 1100 trans), just a lot stronger to keep 700psi in Share this post Link to post Share on other sites
