Leaderboard

Got an email from Michael today, my book has been despatched,

Thanks Guy's What I didn't mention last night is the er... Slight change in how the 6x6 steers as you will see

Your own version of WH Red Square

One of my Tarpen shaft drive sets is called Bill because its got a Clinton engine in it...

My first two "ride on's" were both Westwoods... Quite strongly built machines but it's a shame they skimped on the glue that holds the paint on

Well, yet another day in the shack trying to get the 6x6 driving again, and what do I have to show for it!!! Only a few photo's that were grabbed from some video footage Going in!!! In! Coming back out after remembering 1 second too late that there was a tree on it's side in the nettles! The Raider looks like it's angry with me! At least it wasn't only me that crashed the poor Raider And to finish off..... Going up

Jolly Good, will look forward to seeing you all

Not long now The 6x6 WILL be ready for the show

Saw this post after trawling the net for other info measurements are:- 118mm from the washer shoulder to the end part (sump0 dipstick The rod diameter is three sixteenths the rod is cut to form a half moon in profile at dipping end to a total length of 20mm there is a line halfway at 10mm ... this i take to be the median oil level.. this bantum is new to me as well and i am not familiar with the measurement yet either regards Vig