Leaderboard

Hello, I just got this mini outboard I have some questions. First time on any forum also I'm not to sure how this goes Can anyone give me a link to where I can get a new diaphram? My fuel line falls off very easy I don't think it's correct. Where can I get the correct one, I got it running briefly there's is airbubbles in the line when I push the prime button. It starts then dies after a few seconds, unless I repeatedly push the prime button to force fuel in. Lastly I need a fuel cap mine spills gas everywhere when it runs. The one on it is from some sort of bottle. If anyone could help me I'd appreciate it, hard to find much info on it.

Thank you Gents!. Still learning as I go and making reasonable progress. Finished the parts for the front caster assembled here with a temporary bolt, so just the wheel to make- I had to make the 1/2" BSF Pin Bolt to ensure a good fit and with fine adjustment. I have some 15/16" AF high carbon Hex steel, so set to and turned one up on the lathe- Also made a nut. I bit the bullet and started 'tacking' the frame joints and managed to continue with reasonble weld joints to form a strong frame. I wll need to get the upper surface joints properly done. The mahogany planks have been cut and temporarily fitted for trimming to bring the surface level with the frame's surface. Embelishments include a brass nut cover to keep it weather tight- .........and we all like to 'trial assemble', so this gives a better image of the project- Regards