meadowfield 1,900 #1 Posted April 29, 2015 For those wondering what to use and on some models - how to cut the holes out. it's called grip tape and is used on skateboards - so easy to come by on that auction site. Cut to shape with old scissors or a stanley knife. if you need to cut holes, then mark them from the underside in pencil. I just traced round them on a flat surface after marking 1.5" in from the edge. I then made punch from a piece of chrome pipe - turning the edge sharp on the lathe, and then with a hammer on a piece of rubber mat they were cut through. and voila... Bendy has grippy footplates 5 Alan, HeadExam, Triumph66 and 2 others reacted to this Share this post Link to post Share on other sites
Ian 2,417 #2 Posted April 29, 2015 Handy tips there Mark Share this post Link to post Share on other sites
Stormin 4,458 #3 Posted April 29, 2015 That's what I've used on the C-81 and C-121. I've added a piece on the rear of the foot plate as well, to stop boot heels marking there. You can just see on the photo below. 3 neil, Triumph66 and Alan reacted to this Share this post Link to post Share on other sites
Triumph66 1,256 #4 Posted April 29, 2015 A very good and useful tip Mark. Norm, that's a superb looking WH you got there. Share this post Link to post Share on other sites
Charlie Smith 192 #5 Posted April 30, 2015 Looking good Mark, It's all these little finishing touches that really make a machine! Share this post Link to post Share on other sites
Tom 215 #6 Posted May 12, 2015 Thanks for the tip, I ordered some skateboard grip tape last night for the C120 Tom Share this post Link to post Share on other sites
