Leaderboard

Happy New Year! This is a model J gearbox engine from a Polaris Power Pole snow blower. Recently member @seb T was asking about a gearbox for a Devillaine Ouragan car. So I had the engine out anyway and needed to pull the gearbox to verify if it would fit his engine. Well I might as well rebuild everything. Gearbox with a new seal and gaskets. Plus the entire engine just in case he is interested in a completely rebuilt package. Got everything cleaned up tonight. Tomorrow I'll remove the head and re-ring the piston and put her back together.

As best as I can tell this is a first generation drillgine with the O&R type 100 3/4hp engine (serial 013352). I bought this drill a while back. It was seized up tight. I tried my best to save this one. It sat in my heated ultrasonic for three days vibrating away. I even went to the extent of putting the crankcase in my lathe to cut the cylinder off to save the piston and rod. Sadly the engine was too far gone and it was not meant to be. When my parting tool grabbed the port on the steel liner the crankcase got pulled out of the chuck on my lathe and bye bye went the crankcase. I was able to save the crankshaft from this mess. I am not going to get around to this project anytime soon so I figured I would offer it up for parts should someone be needing them for their drillgine, or if someone wanted to be ambitious and rebuild this one. I did find one repair on the drill which actually looks well done. The drill case has been tig welded up and someone added a little bent steel bracket to better support the handle. I realize this is not in great shape, and I am not looking to get rich on it. I will ship this drill anywhere in the USA. Please send me a private message if interested with your offer. Thanks Chris

Got the engine done and mostly assembled but still need to do carb top half and recoil. Has a nice hot blue spark just spinning by hand and very good compression. Didn't need to do rings as everything with the cylider and piston was clean and good like this engine had very low hours. Definitely not as fast doing this as I used to be. And spent a bunch of time looking for escaped bearing rollers! LOL I let a few out by mistake when not paying attention. Feeling old as I can't see very well and the hands aren't as steady putting those little bearing rollers back in. I'll wait to grease the gearbox.