S1g 579 #1 Posted December 15, 2015 Here's my late 1950's wacker plate. 3 wurzel, Joe the small engine man and Ian reacted to this Share this post Link to post Share on other sites
Ian 2,417 #2 Posted December 15, 2015 It looks in very good condition for it's age What size is the engine? It looks quite small! Share this post Link to post Share on other sites
S1g 579 #3 Posted December 15, 2015 And here it is now that the restoration is almost finished. It looks in very good condition for it's age What size is the engine? It looks quite small! It had been semi restored a few years ago, but stored badly. I believe the engine is about 75 cc two stroke,Ive had the engine fully rebuilt by an ex Wacker employee that I know. They were originally a JLO engine that Wacker purchased the rights to. Still has its original wire rope recoil,can a bit lethal if it kicks back. 3 nigel, Stormin and C-101plowerpower reacted to this Share this post Link to post Share on other sites
Stormin 4,458 #4 Posted December 15, 2015 Nice job as usual. 1 S1g reacted to this Share this post Link to post Share on other sites
nigel 1,876 #5 Posted December 16, 2015 Spot on once again 1 S1g reacted to this Share this post Link to post Share on other sites
S1g 579 #6 Posted December 16, 2015 The plan is so long as my entry gets accepted to take a small display of classic light plant from the late 1950's to 1980's to tractor world in February. Share this post Link to post Share on other sites
S1g 579 #7 Posted December 16, 2015 Here's its brother now it's finished, an upright rammer. 2 Stormin and nigel reacted to this Share this post Link to post Share on other sites
Chris 642 #8 Posted December 17, 2015 When I turn my lap top over I can see you have done a fine job 1 S1g reacted to this Share this post Link to post Share on other sites
S1g 579 #9 Posted December 18, 2015 When I turn my lap top over I can see you have done a fine job They were the right way up when I posted them, must be the iPad, for some reason I never seem to get on with uploading off it. Share this post Link to post Share on other sites
Mister Mad Mower 64 #10 Posted September 23, 2016 Nice , I owned a JAP ( light metalic blue colour ) whacker around 25 years ago , it took 2 to lift it with a struggle as the base was a cast iron block around 24" x 12" x 3"( opposite way to modern machines ) which was machined out in the front section to act as the silencer , sold it to a lad who wanted the engine to drive the propulsion fan on a hover craft of all things ! . Share this post Link to post Share on other sites
