Leaderboard

I still have 3 saws in the mail, will arrive soon, I'm near close to 50 saws in just over two years. All these are auto oiler direct drive models with manual override made between 1965 and 1985.

Thanks Doug don’t give up on me posting as I am busy this time of year on the farm I will try get some new pic to post for you all on here

HeadExam, One of the seals that is hard to find is the induction shaft seal. The dimensions I get from a micrometer are 0.36” ID x 0.5” OD x 0.094 cross section and it’s a pretty simply U-cup shape. Clint Edit: Several posts replying about the 13A/13B shaft seals moved to new thread here: David, It is a little hard to start at first but once it fires I can generally get it to fire again after a couple pulls between the 1-2 seconds it dies. I poked a needle in the vent hole again this evening and was able to completely clear it. I then used a piece of fuel line and blew air into the fuel tank through the vent hole and the pressure exited through the hole so that appears to be working now. I think I’m going to tear the whole thing down and check the seals and fuel lines. I’m a little hesitant to go too far since the seals and gaskets aren’t available. I also don’t have replacement reed valves or any of the rubber gaskets that go between the reed valves and the case. This may end up on the shelf as a display piece only.

Fully restored little Wonder hedge trimmer my first Ohlsson Rice now I'm hooked 😊 VID_163950426_021851_815.mp4