I’ve been wanting to dig into this one for awhile. Finally got it 97% disassembled. The main bearing on the blade pulley is a little raw. Would be best to replace it or at least get at it to put some bearing grease in there. I’m not sure how the roller spindle comes apart. There looks to be a clip holding the back of the shaft but it also seems like it may have some sort of taper fit like a crank shaft. Has anyone had one of these off before, any photos or tips?
Someone has been inside this machine a few times. There were all sorts of make-shift gaskets and seals, horrible job. Worst part about the whole thing is the spark plug threads in the head are completely stripped out. I mean, how hard is it to thread in a spark plug? If you can’t do that then you should definitely NOT be operating a gas powered circular saw! The coil is also going to need some TLC, wires are all cracked and split. There was also a pretty terrible splice job on the power button.