I am going to put a generator together and on the generator end on the shaft there is a washer that goes above the snap ring and a bearing goes on. Does the larger opening of the bearing go up then the generator cover? thanks.
My tank was leaking also so I heated the plate and removed it. I replaced the rubber fuel line and filter that was on the tube and after I cleaned the tank and plate I coated the edges with cream gas tank sealer and put it together. Then I made a mistake. I put some cream inside the gas tank to reaseal the inside edges. It disolved the rubber fuel line so I had to take it apart and just seal the edges and now i am letting it cure.
I found out the magnet on the flywheel is not as strong as another flywheel I have but I found out the magnets are made of a different metal than the older ones in a wico magneto so you need a stronger magnet charger. Also on a generator with the gas tank on the bottom how do you replace the tube and filter? I can't tell how you get the hose connection off the tank so you can get to the tube that is inside the tank.k
I have a magnet charger maybe I will make a jig to remagnetize the flywheel. I just set the points at .020 they were a little closer but the same conditions.
Is there a way I can upload a video so someone can tell me what they think is wrong? The video is over 16 mb to upload it. I gapped the points .020 iI put new diaphragm in the carburetor and made sure the carb was clean.
I was wondering what else would make my tiny tiger misfire. I replaced the coil condenser points and made sure thery were clean. I have a video of it running but not sure if I could atach it.
I put that cap on the points spring to keep the points from shifting on the pin and after it warms up runs good thanks. Bob v can you send me a email lost your address.
I looked at another engine on the points setup and on my tiny tiger there is no piece that is supposed to fit on the points spring pin to shield the points cover so maybe it is grounding the cover to the points so I am going to fix that tomorro
My tiny tiger runs iratically and I tried adjusting it, I canged the condenser and coil with no difference. Could the points cover have something to do with maybe grounding out the points? I gapped the points at 20 thousandths.
