Leaderboard

I'am going to sell this Wheelhorse and thought I would offer it here first. Its a Wheelhorse A90 1977. Just had new battery and exhaust. 8 HP Briggs engine with 3 speed tranny. Has been repainted by previous owner. Good tyres and heavy duty towbar. Starts, runs and drive's nice. No deck !!. One of the smaller Wheelhorse's ready to use or show, starting price £300, so be quickl

"WOW" says it all Mark :thumbs: :thumbs:

It's looking really good Mark not long now until it has it's engine put in!

Just noticed you cut the gear stick off, you just need to undo the set screw to lift it out....

I can't get it in the workshop due too the 2 million wheel horses in there

Well after having a sleepless night due to Mark mentioning articulation and Chris mention having a rear lift axle I decided to do a little redesigning and I've now made the rear axle articulate , I still got loads of work to do on this but I think I going in the right direction with it . I'm just making spreader plates which will be facing each other on the pivot point which will have grease between the. Similar to fith wheel coupling on a lorry to help it articulate and spread the load . Here is what I've done so far !

Brilliant workmanship. Look forward to seeing it finished.

Not much I can add to the last few post's Mark, only WOW!!

At this rate Mark, it won't be long until Bendy is moving under it's own power

It's looking really smart mark you do set the Bar high for us to compete with keep it up mate ,can't wait until I see it the flesh again well done James

Well big progress today Bendy is back to a rolling chassis... I fit the remaining oil seats in the front transmission, ordered some more woodruff keys and started the reassembly process. Lots of new nuts and bolts, its a shame to fit rusty ones back in especially when you can see them..... well I did cheat reusing the old ones for the transmission and the wheel bolts, 7/16 unf are hard to come by and not so cheap. I'm going to buy some zinc and have a go at electroplating them. Also got the remote shift working the forward reverse, just the high low lever to fit. the cat sneaked into a shot

lucky old you ian you could get the engine vapour blasted that will bring it up to an intense shine without much elbow grease on your behalf which means you could spend your time getting the tractor finished

if you hang on ian i should be having a big lathe turning up at my place in a couple of weeks and i will be needing a bit of a lesson of how to use it properly