Leaderboard

Got a drawing of the steering wheel, just need to make some sort of jig to bend the 3/8 bar round.

The verges on our lane are encroaching on to the tarmac. Not that there's much of that. Mainly a patchwork with holes. Not fancying cutting it back with a spade, I had an idea of doing it with one of my GT's. I had this scrap saw blade lying around. Fixed a bolt into the end of some box section and welded another piece to it and drilled a hole. I know the welding is not much cop but it will do for test purposes. With blade in place, things look like this. Add a bit of weight. After a little test then blade had it's teeth removed and an edge ground on. It does cut, but more to do. Needs a scraper of some kind to cut under the sod. I have something in mind. Would be better mounted on the front of the tractor or even mid mounted. Be seen and controlled better when in use. Might be yet.

Just got home from a good weekend at Biddenden, here’s a few photos of the Horticultural section.

Nothing like the old type blue print.

I have thought of that, but that's extra work and not necessary really. Cuts fine as it is. Also safer.

If you put it on the front or mid mounted you could put a pulley on it and run it off your PTO

Good photos thanks good turn out of Ransomes MG machines.

Again!

At least I towed you round the arena with a Wheelhorse.

My batch of photo's are very similar, so I won't duplicate. Chris, DON'T tell Norm I was playing with Ian's Bolens.

OK. Biddenden then. No more excuses.

No, I haven’t made the steering wheel and won’t get the dimensions till Sunday.

Little bit of assembly work.

Its had a coat of red paint.