Leaderboard

Here's mine...

thanks for the info on the bar i just went through my kids rooms and in my 4y room found a broken toy car cut off the rod for the tire sized and filed to fit snug it looks like the original one

Any ideas what application a Type 150 would have been used for?

Good advice, I have a damaged generator here (mentioned in post #2) the governor malfunctioned causing the engine to rev to silly speeds, unfortunately in the process of trying to figure out why, the generator was damaged. The cause was an early all metal governor vane being bent out of shape, it rattled it's self out with vibration from the engine. I have since scanned & uploaded the later Tiny Tiger manual here (section 4, last one); I still have an earlier Tiny Tiger manual to upload in the future. Sounds like someone took the starter apart incorrectly by drilling out the rivet, you should never need to drill out the rivet as it only holds the starter reel bearing in place, the spring & starter cord can be serviced without removing the bearing. David

OK thanks for checking, sometimes they did add dates and sometimes didn't. This is my later 13B Grow Gear trimmer, the handle is different but it has the same plastic gas tank. The earlier Paramount (re-branded Teles in the UK) hedge trimmers have a very similar gearbox & cutter assembly, but use the vertical round gas tank. David

It shouldn’t be an issue, especially since most of the rim looks ok, it just has to make contact with the bottom of the carb when the lever is pushed down. I’ve seen much worse that still work.

Look what I found ! not exact but very close. Now I can but-her on the shelf and Find a new project

Oye ime nearly an old age pensioner you know I have to watch my penny’s now, it’s ok for you northerners you’re weeks food bill is about the same as a loaf of bread down souf 😂

Yep I understand that, but I think he said it had an old Honda engine in, and I thought I would have a lot of trouble finding the right engine for it, but as it happens the showmans got one for sale, I will look forward to the restoration of this one because ime sure you will do it to your normal very high standards and it will end up better than new.👍🏻

I'm working on a different approach making the original bearing retainer bigger in the center to add a seal I'm not sure but the aquabug has a seal like this and i found a seal that looks like it will work. I have a man making me the tooling and hope it works out.

Pretty sure I’ve got the right engine for that, all complete and be heard running