4x4forks 258 #1 Posted June 2, 2018 Had a nice day outside in the sun making a mower for cutting down the ditch on the side of the road. I had made a pulpit to stand on when cutting hedges, That was made from a worn out tractor mounted , lawn brush. I have mounted a very rusty mower deck to the side and lifted by a electric winch sat on the back. I will take more photos when i test it 5 Cub Cadet, Stormin, nigel and 2 others reacted to this Share this post Link to post Share on other sites
nigel 1,876 #2 Posted June 2, 2018 Think I would be a bit worried running the engine at that angle 1 4x4forks reacted to this Share this post Link to post Share on other sites
4x4forks 258 #3 Posted June 3, 2018 Ha! no that angle is just for transport only. it is capable of going over the bank and down into the ditch. 2 nigel and HeadExam reacted to this Share this post Link to post Share on other sites
4x4forks 258 #4 Posted June 24, 2018 Well we have been testing today as my test pilot has returned . It works really well. The first problem we encountered was the engine would die as the plug shorted out on the long branches and leaves . Bit of tape sorted that. Chops up hedge cuttings and blows them deep under . Cuts right under hedge without you getting scratched to bits and cuts down into the ditch so i can at least see the edge of the ditch and not drive into it . 4 nigel, pmackellow, Stormin and 1 other reacted to this Share this post Link to post Share on other sites
Scottwilson 76 #5 Posted June 27, 2018 Looks like it’s doing the job 👍 1 4x4forks reacted to this Share this post Link to post Share on other sites
