Jump to content

Leaderboard


Popular Content

Showing content with the highest reputation on 01/02/2021 in Posts

  1. 1 point
    pmackellow

    Happy New Year

    Happy New Year to all forum users Lets hope 2021 is a better year for us all Paul and Wendy
  2. 1 point
    Photos are becoming a bit thin on the ground now. Under the back seat there were two crossmembers on the chassis with plates for holding two six volt batteries, one of these had to be replaced and I decided to convert it to one single 12 volt battery while I was at it. I test fitted the new battery and noticed a bit of a spark as I put the terminal on and thought that everything was switched off and it was. I knew the wiring to the back of the car was needing replacing but when I added an ammeter to the main cable there was a 3 amp discharge with nothing switched on, so the rest of the wiring was now suspect. There were a couple of burned wires under the dash, several added wires under the bonnet and a couple of duplicates to the front lights, the club came to the rescue with a wiring diagram and it really isn't a complicated system and I removed the lot to start from scratch. Although cotton braided cable is available the thought of measuring the various lengths, making sure I had enough and getting the right colours seemed a bit too much like hard work. I had plastic covered wire from 2 Triumph 2000's a Mark 10 Jag and an XJ6 all in BL colour codes so decided to follow their coding system and make up my own loom and use some vintage style trunking to hide most of them. It was a cold spell and paint wasn't drying, glue wasn't going off so I thought I'll do the wiring but hadn't reckoned on trying to straighten out cold plastic wire that had been coiled up for the best part of 25 years, it was a real pita to feed six or seven cables through the trunking and had to pull some through two or three at a time with a squirt of WD40 to help it along. Once done it looks quite in keeping with the rest of the car with only a couple of inches at the control box showing and fixed to the chassis with brass clips Two solenoid were added for the horns and the headlights to lessen the load on the wires passing down the inside of the steering column and the underside of the dash is also a lot neater. The reconditioned steering box was also fitted at this stage before a new plywood bulkhead section around the pedals and steering column was installed. This is the final tally of all the woodwork that was replaced
  3. 1 point
    Further progress on the Bolens HT snow plough replica despite the workshop feeling like it is 10 degrees colder than outside and the outside temperature is at freezing point. The workshop soon warmed up or we got the hang of the temperature. We finished work on the swivel, started making the clevis forks and finished the main frame. Video of progress
  4. 1 point
    Jarrovian

    Happy New Year

    Happy and prosperous New Year to one and all
  5. 1 point
    Aiberdonian

    Happy New Year

    Hogmanay in lockdown - bah humbug! As I raise another glass of navy rum A guid new year tae ane an' aw and mony may ye see.
  6. 1 point
    Alan

    Happy New Year

    Happy New Year to all.
  7. 1 point
    Stormin

    Happy New Year

    All the Best one and all. And here's to a much better 2021.
  8. 1 point
    Hillsider

    Happy New Year

    Happy and safe new year to all from Dover.
  9. 1 point
    CNew

    Happy New Year

    Happy New Year to you as well Paul!
×
×
  • Create New...