Leaderboard
Popular Content
Showing content with the highest reputation on 05/19/2015 in Posts
-
2 points
Disc harrows
nigel and one other reacted to the showman for a post in a topic
Hows that, this was tea time, all back together and working and adjusting -
1 point
Disc harrows
pmackellow reacted to the showman for a post in a topic
While i was out today collecting mine and Norms ploughs i found a set of disc harrows that are adjustable, i just had to have them -
1 pointCame across these in a local auction never seen anything like them so thought I'd bid on them 3 flymo advertising printing plates and 3 but 2 different merry tiller print plates Sent from my iPhone using Tapatalk
-
1 point
Disc harrows
Triumph66 reacted to the showman for a post in a topic
Had a bit of a play with them this afternoon, here's a couple of photos -
1 pointWicked find, yer don't see many of those around. Thanks for sharing
-
1 pointThose are an unusual find and pretty rare I would think.
-
1 point
Local auction find
mowerdar reacted to pmackellow for a post in a topic
Good find, bet there's not many of them left -
1 pointUse a small amount of hardener (ratio on can) to any Alkyd enamel paints and it will make the shine last long , enhance color retention, durability, and make more resistant to fading and scuffing. Be advised that what you mix up will have to be use,d as it starts chemically drying upon mixing, and will set up in a can in a day or so. http://www.paintdocs.com/docs/webPDF.jsp?SITEID=KRI&doctype=PDS&prodno=075577025220
-
1 pointtry these, i have not used them yet but http://www.riolettcustomaerosols.co.uk/cheap-ral-paint/ral-6025-aerosol-spray-paint/
-
1 point
Bill Targett Memorial rally 2015
HeadExam reacted to pmackellow for a post in a topic
A great day in Hampshire yesterday at the Bill Targett rally We took our collection of Jobbers and tools (as they were made in Winchester) Steve Denness took his Jobber and Nash Boadicea mower Here's some photos... -
1 pointAnother nice Ransome
-
1 point
Bolens 800
Triumph66 reacted to meadowfield for a post in a topic
Looking for a quick sanity check lads, I'm good on the standard Bolens decals as I ship quite a few. However I've had to draw one from pictures at jaunty angles and would like a quick check it's ok... thanks -
1 pointWeather turned sunny this afternoon, so out came the paint. Two coats grey primer, two grey undercoat and two of silver. In between coats a spell in the low bake oven. That's where they are now.
-
1 point
Bolens 1556 Restoration
HeadExam reacted to OldBuzzard for a post in a topic
Yes that bend should be there. It's normal for the hydrostatic tube frames. -
1 point
The plough twins
HeadExam reacted to The Fife Plooman for a post in a topic
Hi All Then there were three This is my auto culto plough made to fit behind my Gutbrod 1032 Still to try it out
