Leaderboard

My mate Dunc had an old buck rake of unknown origin lying about. For fitting on the rear of a tractor. We'd got it into the workshop last week to see what we could do with it. First thing was a new hydraulic hose which Dunc had got made earlier this week. With that fitted we set too to make it into a forklift, for mainly moving crates of firewood. First we cut off the two outside prongs and the centre one. Then some scrap angle iron was welded to the now outside prongs. This was to extend them to reach fully under a pallet. Pleased to say things worked well. And cheap as well.

The only shipping option turned out to be express, might have been a bit longer if they weren't available in Europe. They should fit, will confirm at the weekend. David

All the Best, Doug. Hope you had a good day.

Newark tractor and heritage show to round off the year A few photos starting with forum member Dave Foster and his prize winning Allen Scythe, well done mate !

Wayne PC1 & PC2 pumps apparently use a smaller diameter impeller, listed as "Impeller dimensions: 1-3/8" Diameter, 1/2" Width D Shaped Key Hub for 5/16" Shaft" here; https://www.amazon.com/Utility-Water-Transfer-Impeller-Replacement/dp/B06XDHJYVL/ There is still the possibility the whole pump assembly could be removed from the electric motor and adapted to fit one of these engines missing the pump unit, you would still need to make the shaft adaptor if the original was missing. David