Leaderboard
Popular Content
Showing content with the highest reputation on 06/09/2017 in all areas
-
3 points
The Travels of a Sears Roper
expeatfarmer and 2 others reacted to the showman for a post in a topic
Had a drive over to Newby hall this morning and delivered the Roper to the new owner. he looked quite pleased with it. -
2 points
Newby Hall Tractorfest. Ripon.
nigel and one other reacted to pmackellow for a post in a topic
Tractors unloaded this morning, looks like another good show... -
1 point
Newby Hall Tractorfest. Ripon.
pmackellow reacted to Alan for a post in a topic
They all look smart Paul. -
1 point
Newby Hall Tractorfest. Ripon.
nigel reacted to pmackellow for a post in a topic
Thanks mate its not come up too bad -
1 point
Newby Hall Tractorfest. Ripon.
pmackellow reacted to nigel for a post in a topic
That r20 is looking very smart paul -
1 pointThe new coil armature requires setting up as follows. Turn the flywheel so that the magnets are furthest away from the coil . Pull the coil as far from the flywheel as the slots allow and pinch up one coil fixing screw. Rotate the flywheel so that the magnets are equally aligned with the coil armature legs. Place your gauge ( plastic or card ) between the armature legs and the flywheel. Release the screw that you tightened and the magnets will pull the coil onto the flywheel pinching the gauge . Tighten both screws and turn the flywheel to assist pulling the gauge out. In the absence of the correct gauge, Briggs used to suggest two thicknesses of an outdated micro fiche.