Jump to content

Leaderboard


Popular Content

Showing content with the highest reputation on 03/05/2020 in Posts

  1. 1 point
    Cub Cadet

    Wheel Horse Clevis Hitch

    A while back I noticed a few people asking about these hitches on a Facebook page, thought I’d have a go at making some to see if I could sell any. Here’s how far I’ve got. First job was making a jig to put the 90 degree bend in some 10x50mm bar. needed some 1” square bar to fit in the hardy hole of my anvil. This is the jig I made The round bar fits in the pritchel hole to keep it sturdy Works a treat All the same Next hurdle was putting the cranks in the bars, I made up an attachment for our hydraulic press 9 tons of force to put these bends in
  2. 1 point
    JUST O&R

    This weeks project

    Thanks David that helped out got all the spacers cut and found some nuts for the top. The top cracked a little when I tightened the nuts but not bad . I will live with it for now but still came out ok. .
  3. 1 point
    pmackellow

    O&R boat engine

    Now cleaned up and on the shelf with the others...
  4. 1 point
    the showman

    Wheel Horse Clevis Hitch

    Nice job Ewan,
  5. 1 point
    Cub Cadet

    Wheel Horse Clevis Hitch

    Cheers Norm, Once finished I’ll work out cost and let you know
  6. 1 point
    Stormin

    Wheel Horse Clevis Hitch

    Handy having the forge and press. Put one on one side for me please, Ewan. I'll collect at Newby Hall.
  7. 1 point
    Cub Cadet

    Welding trolley project

    Quick little fabrication project. I repurposed this 3 wheeled walker thing that my grandad got his brother as a joke present . I didn't use any of the original tubing as it was quicker to use square stuff we already had. The bottle sits low down over the back wheels for stability. The old adjustment knobs were used to attach the chain, works well. For the novelty factor I used the handles makes it easy to push around. All finished, its proved very useful so fair when moving it between workshops! I might add some bars on the sides later to hold the welder and plasma cutter on properly. Works well enough without them though
  8. 1 point
    Anglo Traction

    Downsizing in Metalwork

    Hi all, thanks for the positive responses. Certainly a different way of working when producing scale models without plans or castings etc. Everything takes longer and a lot of thinking. Managed to reach a point of trial fitting the spray bar parts today which I've been working on for a while- I stripped the chrome off of a 60s car aerial section which was the right size in hard straight brass (5/32" or <4mm). I failed with reproducing the flanged connecting pipe, as it should be straight and I had to 'dog leg' it to line up. Probably as a result from having to work from a basic drawing for sizes of a similar make of cart. Still, it's a reasonable representation until I can get to M.E.R.L to inspect the company's original drawings. The retaining brackets were an excercise in miniature milling and retained with 12ba coach bolts/nuts- Time to start drilling loads of tiny holes............I may be some time !. Regards
×
×
  • Create New...