Hi Richard, hope your keeping well..
Robot Wars eh... It's been a long time since I last watched it... Is it still going?
The last time I heard anything about Craig Charles he was/is doing a Funk and Soul music show on BBC 6 Music!
Not that I have anything against a bit of Funk you understand
It would be cool to catch up with you again Richard, no rush whenever is good for you
Now for a fun video
The stripdown should of taken a day at the most, but when everything is being video'd using my Camera Panning Jig Thingy, one day gets stretched to five!
With the frame stripped down I could make a start on the final welding.. Well, almost
The last couple of bit's of "made out of a cheap office desk" Quadzilla frame were bugging me..
The only problem was important bits such as front suspension lower mounts and front diff mounts are made out of one big plate that's welded to the Quadzilla frame.. And it's kinda important to make sure these mounts stay in the same place.
So after a lot of bracing including something to hold the said plate in the right place, the lower front got the chop!
Would you look at the rust in that!
At some point during the build the bit of tube that these two bit's of desk are attached to was welded in not quite where it should of been.. In other words it looked pished but wasn't noticable until everything had been stripped from the frame!
Cleaning the suspension plate of the left over bit's of rusty desk took a while, here's the plate bolted back on where it should be..
A bit of space to fill to connect everything back up again..
A lot of new thick wall tube has gone back in the front, but I forgot to take any photo's yesterday..