Leaderboard

Part of my Workshop stock tidy up. This carb is from a 1981 K301 engine. I have completed what is known as a full rebuild on this and is returned to virtually new condition. What has been done was covered in a Topic on Redsquare a while back, so I've added a link here for scrutiny- -CARB- Yes, you have the option to pay much less for a new Chinese copy, but this one now has quality built into it to run for many more years with some care. It was assembled with a new repair kit, super clean inside and out. Stored in that condition until I set it up on one of my Tractors to adjust the settings for correct running mentioned here in this link- Set up Carb on K301 Returned to storage until now. Should bolt straight onto a K301/M12. Note- this was set up and adjusted on an engine in good condition and a clean Air Filter. You may still need to make further adjustments. Includes the Governor Arm linkage and Fuel inlet elbow £45.

A couple of weeks back, maybe more, it's me age, I replaced the drive belt on my WH C-125. The old girl gets used far more than her stable mates. Mainly mowing duties on the green and verges around my abode. Yesterday after mowing, I put the lawn sweeper on to tidy up a bit. I say a bit as the rate that the leaves are falling it's darn near impossible to keep things tidy. The corner of the green between the junction of lane and bridleway, is slightly steep and where I usually drive onto the green to start work. As I drove on with the sweeper, the old girl was struggling in 3rd H and half revs. Usually not a problem. Engaged low box and up she went. My first thought was the drive belt slipping. This morning I decided to investigate. The belt was a tad slack and I noticed the clutch pedal when released, was against the foot plate. So I removed the connecting rod, after removing the near side wheel. The trunnion adjuster was rather tight so needed freeing off. Probably never been touched in 36yrs. Replaced the rod with the trunnion not screwed as far on and the pedal clear of the footplate. Happy to say success and the old girl climbs the slope with out any todo.

Got home earlier than expected so I've finished the pulley, The old hub is now welded on and the hub on the other side machined of on the lathe. Considering what I've done it runs quite true in the lathe so I'm pleased with that.