Went in the workshop a few times yesterday and could smell petrol. After tea it was annoying me and had a good hunt around, the fuel tank on bendy spontaneously split open and emptied itself ....
Definitely earth leakage, is there a neutral in the wiring? Should just be three wires and and earth. Your incoming should bring neutral in as a tap from the transformer.
my lathe is a 4 pin plug, of which one is earth. The motor is delta configuration and uses three wires. Any combination works, if the motor spins the wrong way then swap two.
Pulled up the floor in the downstairs loo today. Needed some help.... Finn to the rescue, any excuse to hook up a trailer. He's really good at reversing it too.
Spent a bit more time, fork done. Just the actuator to sort. I've tested the pulley at fixed settings, and manually pushed the fork with the engine running.
Just make a puller, there's usually two 5/16 threads either side of the nut. A piece of 1/2 bar and screw them down and then tap the centre and they pop off
Typical
in Metal Shop
Posted
I've started my next project and ordered some laser cut discs 12mm x 181mm. Based on my careful measurement of my lathe swing...
Doh!