Morning all, a long overdue update for you all...
I have been thinking about the suspension, but for a machine who's main roll in life will be to smoke the rear tyres/tires away, I'm not 100% sure it's going to be needed.
with the low height I need there also wouldn't be any real suspension travel, maybe 2-3 inches!
Also no suspension would make the build a tad easier!!
My current thinking is something I saw on a racing mower which I am told works very well and saves a lot of back pain!!
From the front it's hard to spot..
A bit of a give away at the back though
Anyway, I'm not quite at that point in the build yet, but not the far off..... Yes work has finally started on Project Wheel-Vo
I havn't quite finished my MadTrax quad build yet, but I had got to the point where I needed a few bits to finish it but no cash to buy them.. (Ordered this morning by the way)
But MadTrax had reached the point where it could come off the bench... And as the bench was empty of course I needed something to put on it
Engine, trans, a few wheels and the bonnet plonked in place..
Although the look is rather grin worthy, there are a few problems such as the bonnet is too short, too wide, and not long enough to not onlt fit over the engine but also cover the radiator, intercooler and tran oil cooler!
Sooo best add 12 inches to the length and 4 inches to the width..
At this point I am not sorting the bodywork out, I just need to stretch things a little until Wheel-Vo looks right hence all the random bit of tube and box holding the bonet together..
The fender pan got a bit of a stretch as well..
"Now with an added Nigel" to help you work out the scale..
This is a good point to drop in a video as it kinda covers all of the above.
What it doesn't cover is the fender pan getting lengthened a bit..
Seeing the fender pan just resting on the top of the tyres was bugging me, so to get it to stay in the right place and height it gained some legs..
Only one thing for it... Get the ladder out and climb aboard to see how it feels..
The view down the bigger bonnet from the seat is amazing.. You will see it in the next video..
Yes the seating postion looks a bit high, the middle of the fender pan will be chopped out and lowered to get the seat and my vast weight lower..
A couple more pic's without the fat bloke...
And that's as far as the build has got, the next job is to copy the fender pans lead and makes some legs/stands to hold the engine/trans in the right place and screw it down to the bench.
I still need to tweak the panels around a bit, but I'm not that far off of thinking about the chassis..