| |
-
Don't worry Iain its got to get past me and Alan first
-
A BOLENS part ? How have I ended up with that. the only Bolens ive had was a ram and that didn't have a deck.
If its any use to you Iain, its yours
-
Looking good Harry, will it be ready for the round-up ?
-
Had a rummage through some boxes and came across these, look a bit similar to the photos
-
You might as well come down now that's nearly finished and pick up your next project .
-
Thanks for your comments Doug, glad you like it.
-
-
I knew ive seen them somewhere,
-
-
They look similar to the blades on a atco finger mower
-
Went out playing today to work off the extra lbs i put on and get away from the house
-
I would have bought it from snap-on or mac tools can't remember which one as both of them called at our garage but at the end of the day you get what you pay for and when you earn a living wrenching quality comes first and a replacement guarantee
-
This is what i used when i was at the dealership, don't get much use now but very handy
-
-
Ive got a tester in the shed somewhere still in the box, hav'nt used it since I retired.
ill dig it out and give you some info and photos later today
-
Not my sort of thing, would look better with the engine lower and a one piece bonnet and 2 stack pipes
-
-
Happy birthday mate, hope you have a good day.
-
Ha Ha, all my stock has doubled in value!!!
-
Nice looking pair, what size tyres did you put on the back of the 401 they look big ?
-
I would just spend an hour and try and fix what you've got before spending out for a new one.
much more fun if you've got the patients
-
As nigel says test the float, you could try just dropping the bowl off and lift the float with your finger and see if it stops the fuel running through the needle valve
-
Good job Darren, the plough looking good, once you start using it you'll be amazed how shiny it gets
-
Some nice stuff there Doug, i like the 520 with the early hubcaps and the cab.
when Pam moans about the leaves on our garden I'll show her these photos,
-
At least you've made some progress, it will be up and running tomorrow .
|
|
