Leaderboard
Popular Content
Showing content with the highest reputation on 09/30/2014 in all areas
-
2 points
Happy birthday Stormin
Vinnetrow and one other reacted to Stormin for a post in a topic
Thanks lads. No horsey pezzies I'm sorry to say Chris. Swmbo did cook me a bacon, egg and fried bread breakfast though. -
1 pointHappy birthday Norm, have a good day mate
-
1 point
Ransomes Mg6 Dumper
nathanwhittaker reacted to meadowfield for a post in a topic
double standards telling me to run straight through -
1 point
Ransomes Mg6 Dumper
Ian reacted to diggerjames for a post in a topic
I've been fabricating a temporary exhaust system today for the dumper here is what I've come with with parts I had available -
1 point
Raider 16 4x4 articulated -aka project bendy
meadowfield reacted to slf-uk for a post in a topic
As I have only recently joined I went back and read the complete thread. The work you have done on this is incredible and the outcome looks fantastic. Iain -
1 point
Raider 16 4x4 articulated -aka project bendy
meadowfield reacted to diggerjames for a post in a topic
Brilliant mate -
1 point
Ransomes Mg6 Dumper
Triumph66 reacted to meadowfield for a post in a topic
-
1 pointhere is our nearly new lathe (1954) it called a little john, any info on these machines would be helpfull, i found out how to plug it in so thats a start
-
1 point
What lathe have you got?
Anglo Traction reacted to Rocboni for a post in a topic
Ive got a Denford 280VS and a Denford easimill with the CNC gear removed. was fun getting down the steps to the workshop, had to be careful i didn't drop in in the pond! -
1 point
What lathe have you got?
Anglo Traction reacted to loggerhogger for a post in a topic
My small lathe is a 12"X24" sears Atlas my larger one is a 1910 18" Greeves Klusman -
1 point
Ransomes roller rescue
Anglo Traction reacted to Wristpin for a post in a topic
Was recently given a Marquis 51 in a fairly sorry state including the two rear roller section seized to the shaft ( no diff action ) and much of the "tread " worn off them. The recovery process involved dunking the whole roller in diesel, "easing" it a bit at a time with more soaks in diesel between sessions , a session under a farmer friend's press and finally recutting the grooves with an angle grinder ! -
1 point
What lathe have you got?
Anglo Traction reacted to diggerjames for a post in a topic
Hi all this my new lathe I've just acquired its a Harrison can't wait to get it installed -
1 point
what are you listening to?
diggerjames reacted to C-101plowerpower for a post in a topic
