Stormin

Just isn't the room really. While the cylinder is off I do have an idea floating about in my head. Thanks for the suggestion anyway.

Cockermouth, Maryport, Wigton, Carlisle, I could go on, all caught to in places as well.

Jonathan will be ok. His place is high up and on the side of a hill. Will have been a bit breezy though.

Correct Paul and I should know better. Had a Marina van myself and we had a Maestro pick up at the farm for a few years.

Nice Marina van.

The pump etc was only meant to be lifting a cutter deck straight up and down. The plough hanging off the back will be increasing the weight it has to lift most likely. I'll get an overhaul kit for the cylinder, than see how it performs. Then I may tweak the release valves if possible.

Quite a collection.

That's bad, Rhys. I'm just thankfull we don't live near a river.

That looks fun. Has he got home yet?

Had to go down to eldest daughters place earlier with sand bags. Water was getting through her back door. Her place is down a lonning with a stream passing under at the bottom. Over flowing it of course and they can't get their cars out. Didn't pose a problem for the Disco.

Did someone say it's been/is raining? View from the decking. Up the lane. Only way in and out. Has been worse. A few years ago you couldn't see any grass. Neighbours place across the green opposite us. Her drains run across a field into a gutter, or ditch, that runs out to the marsh. That's full,

Put it up on 6" blocks today. On the ground I was getting an estimated 4" depth with 3" ground clearance when raised. I've moved the ram connection to arm up an 1", and connected the chain with same bolt as lift lever connecting bar. I've now got a depth of 6" with plough flat on the ground. Just over 3" clear when raised. If I screw the plough right up, I get 5" and a bit clearance. I think this is the best I can hope for. When lifting the plough it will lift, but I think in use, especially in the ground, lift lever and hydraulics will be used. A micro switch will be fitted, to stop the ram in lower mode, before the other arm hits the tank. The one with chain etc connected to. The cylinder now is stripped ready for finding/getting/fitting a new cylinder/rod seal. Got a bit of a leak.

All the Best Steve.

Carve out the lettering, then stain or leave the wood. Fill in the lettering in black or some other colour then coat with yacht varnish. Don't forget the back.

Gas bottle on it's side, flat plate welded on. Big enough for kettle and frying pan.

Rather better than the one I had to sit on. Well done!

How are they taking it out, Koen? Fracking or drilling?

Aren't they in an area of Holland that speak a different language or something?

Just keep clear of any docks, canals or lakes.

Your certainly not wasting any time, Noel.

Got it all up and working now. First some photo's at start of play. Motor and pump piped up. Cylinder in place. As you can see things are a bit tight. In third gear the lever only just clears the cylinder end. Rear fulcrum. Couple of mods done to that before everything was connected up. I had the lift chain attached to the modified hitch at first. That would give plenty of depth, but little ground clearance when up. I then attached it to the slot hitch. That gave me an estimated depth of around 4" and 3-1/2 of ground clearance. Moving the shackle one link on the chain will give more depth but less clearance. I'll put the tractor on blocks and do some experimentation. Maybe fit a turn buckle.

That's turned out quite well.

Bit hard to understand him, but brilliant all the same.

I know the feeling.