Jump to content

Leaderboard


Popular Content

Showing content with the highest reputation on 08/27/2018 in Posts

  1. 2 points
    Fix'em all

    Farmers boy

    In my experience 90% of the time cleaning the points will get the spark back. Hope the carb is ok as that type can be a bit of a pain to work on and tend to leak fuel when the engine is not running.
  2. 2 points
    Sammoore13bolens1053

    Farmers boy

    Check the points, pull the flywheel
  3. 2 points
    slf-uk

    East Coast Truckers convoy

    The majority of the trucks work for a living and I believe the drivers spend a lot of time cleaning and preparing them for the event. Video of the return We had a 2nd camera for the outward journey which shows some better detail. Not sure who parked that Discovery at the side of the road
  4. 2 points
    This one is a 3 litre as well, twin tailpipes, V6,proper job !
  5. 2 points
    joegrgraham

    Farmers boy

    Looks like a B and S off a merry Tiller, the only cut out is the little flap next to the spark plug. Firstly try the obvious, clean up the plug and check the plug gap or try a different one, then take off the cowling and clean up the coil where it meets the flywheel, and check the gap between coil and flywheel. They are fairly bombproof engines, so if you still have no spark, it is probably the coil. Joe.
  6. 1 point
    Stormin

    Tyre change.

    When mowing the green and verges, the grass is seldom dry. If I waited for it to be fully dry, it would never get done. Consequently the grass cuttings stick to the turf tyres on the C-125. When they come off during mowing they lie in unsightly lumps or strips. Also the pattern of the turf tyres makes them a pain to clean. I've decided to try an experiment. I'd the original rear wheels, complete with ag tyres off the Black Horse in storage. So these are now fitted to the C-125. We'll see how things go next time I mow, in maybe a week or so. Another thing I've tried, is to repair a tyre valve on one of the wheels. The valve must have got knocked when in storage and the rubber was partly broken. Push the valve to one side and air came out. This was repaired with super glue yesterday. To date it is holding air again. We'll see how long it lasts.
  7. 1 point
    Have a good day Andrew, all the best mate,
  8. 1 point
    the showman

    Tyre change.

    And no photos again !
  9. 1 point
    slf-uk

    East Coast Truckers convoy

    You may have noticed that I panned onto it as the last truck went past on the first video, couldn't resist
  10. 1 point
    Stormin

    East Coast Truckers convoy

    For some reason I spotted that Disco before.
  11. 1 point
    Scottwilson

    Farmers boy

    Cleaned the flywheel and coil and couldn’t see a spark but got a Jult of the plug when I held it and pulled it over . Cleaned the tank out and got a load of crap out . Now not sure if I’m getting fuel in the carb that’s my next step .
  12. 1 point
    nigel

    Happy Birthday Triumph 66 or 67 now

    Happy birthday Andrew
  13. 1 point
    Alan

    Happy Birthday Triumph 66 or 67 now

    Happy Birthday Andrew. Have a good one.
  14. 1 point
    slf-uk

    Happy Birthday Triumph 66 or 67 now

    Happy birthday Andrew, I hope you have a great day. Iain and Joseph
  15. 1 point
    harryt

    Happy Birthday Triumph 66 or 67 now

    Happy birthday Andrew, hope you have a good day 🎉🎁
  16. 1 point
    Happy birthday Andrew, sorry we missed you at RPT and TF !
  17. 1 point
    Stormin

    Happy Birthday Triumph 66 or 67 now

    All the Best Andrew. Enjoy your day.
  18. 1 point
    Great photos, I also like the early Ford Capris
  19. 1 point
    With the clutch now free I couldn't wait to get it back together. I gave the end of the crankshaft and inside the clutch a light clean and reassembled everything. Using the manual I checked the position of the brake pad and then fired up the engine. Pulling on the clutch lever I was glad to see the drive to the gearbox stop turning, low, high and reverse gears all worked as did the rotor drive. Time for a play (I mean test run). Given how hard the ground is it worked very well. I will change the engine and gearbox oils next before putting it to work. I asked my father how long the 350 has been parked up for and he said he couldn't remember, we've been trying to work it out but the best we can come up with is somewhere in excess of 15 years. My father bought this Howard 350 new when I was still at primary school and I have fond memories of watching him working it every year. It's nice that after a bit of tinkering it is still capable of a days work.
  20. 1 point
    Stormin

    Great Dorset Steam Fair 50th Anniversary

    I like the early Ford Capri. I had a metallic blue one. Also three of the white Cortinas. All 2.0 ltr. One again metallic blue, One orange GT and a metallic brown estate. Weak point was the camshafts. The lobs wore pretty quickly. Easy to change though.
  21. 1 point
    slf-uk

    Busy tractor day.

    The exception to the rule. I had to unblock our drains yesterday. I didn't take any pictures but unfortunately it did happen
  22. 1 point
    A few more photos from other sections at the show... Glad we were not at the GDSF today as the weather has been awful !
  23. 1 point
    I found this guy about six inches off the ground climbing my tomato plant. Proof positive and turtles are agile and proficient climbers in secret
  24. 1 point
    HeadExam

    A Second Garden Started This Week

    Thanks mates, I have a desire to grow all our food for the health benefits and self reliance. The soil is great black topsoil with lots of aged cow manure. The paleness comes from grass clippings that I spread out to hold moisture, hinder weed growth, and add nutrients into the soil
  25. 1 point
  26. 1 point
    I said watch this space... new addition to the fleet. 2010 4WD John Deere 3036e with loader and transport box, will come in very handy around the garden... Here's Ewan having the first test drive
  27. 1 point
    mowerdar

    Tea 20

    Went to a show today bought a few new tools and some how managed to accidentally buy this hehe
  28. 1 point
    phil murrell

    Colour scheme

    Hi All I have just started to restore a Allen Roper 8 its in a very bad condition. Was wondering if anyone has the correct colours codes for it Thanks for any help
×
×
  • Create New...